After searching the old Wasp heads for a long time I decided to make an alternativ way to combine the advantages of the wasp with the advantages of the MK II swinger.

All you need is:
  • 0.077inch Stainless Steel wire aprox.12inch long
  • one MK II head
  • some superglue
  • some pliers
  • a vice
  • Some crafts fate.

Let's begin:
  1. Bend one end of the wire to an eye, that fits into the MK II heads.
    It should look like this:



  2. Shorten the wire as long as you want.

  3. The end without the eye must be bend in a 90 degrees angle to the eye at the lenght of 2inch. If it is to long you must shorten it with a plier.

  4. Now you have to grind of a bit from the wire at the bended end until it fitts into the body of the Wasp.

  5. The next step is to mount it all together.

  6. If everything is allright you can glue the wire into the body of the Wasp.

  7. At the end you only have to bend the wire in a small angle. If everything runs right it should look like this:





Much fun, when tinkering.